Dufur, USA

Ride or run · North Bend, USA
Palouse to Cascades Snoqualmie Tunnel
A gentle out and back on an old railway grade through a two mile tunnel in the Cascades.
Illustration
- 67.6kilometres
- 492metres climbing
- Rail trail or bike pathsurface
The ride
About this ride
This out and back follows the old Milwaukee Road railway grade, now the Palouse to Cascades State Park Trail, from the Cedar Falls trailhead near Rattlesnake Lake up to Hyak at Snoqualmie Pass. The grade is a genuine railway gradient, so the climbing is gradual and steady rather than steep, spread over about 19 kilometres each way before the return descent. The centrepiece is the old Snoqualmie Tunnel, a bore well over two kilometres long through the mountain that stays a few degrees above freezing year round and is pitch black inside, so lights front and back are essential. The trail surface is well maintained gravel on a railway formation, wide and predictable, suiting riders new to gravel as well as those after an easy century of packed miles. Best ridden in the warmer months once the tunnel and higher sections are clear of winter run off and ice; check current trail conditions before heading up in shoulder season.
Good to know
- Riders report next to no traffic.
- Low scores across the board. A good first gravel ride.
Before you go
Washington Discover Pass required to park at the trailhead; tunnel is unlit and cold year round.
Route information from cascade.org · Official route map
- Distance
- 67.6 km
- Climbing
- 492 m
- Climb rate
- 7 m per km
- Surface
- Rail trail or bike path
- Activity
- Ride or run
- Rough time
- 3.5 to 5.5 h
Difficulty
How hard is it?
Fine for a first gravel ride.
Scores from the rider who added it. No reviews yet. Worked out from the hilly, rough and technical scores.Riders say
Rider reviews
Honest ratings from members who have ridden it.







